Kingston HyperX FURY Black 8 GB CL10 240-Pin UDIMM DDR3 1600 MHz (1.5 V) PC Memory RAM (HX316C10FB/8)

Kingston HyperX FURY Black 8 GB CL10 240-Pin UDIMM DDR3 1600 MHz (1.5 V) PC Memory RAM

[HX316C10FB/8]

DESCRIPTION:

HyperX HX316C10FB/8 is a 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module, based on sixteen 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below.

SPECIFICATIONS:

FEATURES:

# JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

# VDDQ = 1.5V (1.425V ~ 1.575V)

# 800MHz fCK for 1600Mb/sec/pin

# 8 independent internal bank

# Programmable CAS Latency: 11, 10, 9, 8, 7, 6

# Programmable Additive Latency: 0, CL – 2, or CL – 1 clock

# 8-bit pre-fetch

# Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

# Bi-directional Differential Data Strobe

# Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

# On Die Termination using ODT pin

# Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C

# Asynchronous Reset

# Height 1.291” (32.80mm) w/heatsink, double sided component

Kingston HyperX FURY DDR3:

Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.

PnP JEDEC TIMING PARAMETERS:

# DDR3-1600 CL10-10-10 @1.5V

# DDR3-1333 CL9-9-9 @1.5V

# DDR3-1066 CL7-7-7 @1.5V

for more info. Click Here

for more Kingston product Click Here